Some plumbing installations are best left to the experts. But a water softener is something you can install yourself. A water softener provides many benefits to your home. A shower water softener makes your skin and hair softer. In the kitchen, it adds sparkle to your silverware. A water softener can even extend the lifespan of your home’s plumbing system. It’s relatively fast and easy to replace a water softener, but you might need more knowledge to install a new one. If you’re ready for a DIY project, here’s how to start.
Choose the Right Softener
There are a few different water softeners that you can install in your home. The best plumber Las Vegas will tell you that they vary in installation difficulty. Some are simple to install yourself, while others may need an expert’s touch. One of the easiest types of water systems to install is a magnetic system. On a difficulty level of one to 10, they’re about a two. A salt-free water system is moderately challenging to install. This varies based on whether it has a media filter or runs on electricity. A reverse osmosis system is also relatively easy to install.
Find a Good Location
As with any plumbing fixture in your house, accurate water softener installation Las Vegas requires choosing a good location. For a shower water softener, it’s best to install the system close to the source where the water enters the house. It’s also usually a good idea to connect the softener to the water heater. You’ll typically want to connect the softener to your cold water pipes too. The exception is if you have a reverse osmosis system or another salt-based water softening system. Two of the most common locations to install a water softener are in the basement or a utility closet near the water heater.
Installing the System
To begin a shower water softener installation Las Vegas, turn off the water in the main line and the hot water heater. You’ll then want to locate the area where you want the softener to go and cut the main water line. Next, insert an elbow fitting into the main line to create a bypass. Attach the pipes to the unit securely, then connect the hose to the unit and place the overflow tube correctly. When that’s finished, plug in the unit to release air and create a flushing schedule.
Bear in mind that like any plumbing project, you may need to abide by buildings codes or get a permit before you start. Also note that if a permit is required, you’ll have to obtain a municipal inspection to verify that the installation was done correctly. If you have questions about these requirements or need help with your water softener installation, don’t hesitate to contact Service Plus Plumbing, the best plumber in Las Vegas, for assistance.
